Inside a 1965 Signetics chip: one silicon layout, three products, chosen by the metal layer
Ken Shirriff has published a die-level teardown of an integrated circuit nobody could identify at first. Under the microscope it turned out to be the ST680A, a quad two-input NAND gate built in diode-transistor logic (DTL) from the Signetics 600 series of 1965. The package was opened with a hot-air decapping method used by CuriousMarc, and a few drops of sulfuric acid cleaned off the remaining epoxy.
The chip had no passivation layer, so the acid also removed the aluminium wiring. Shirriff had to reconstruct how the transistors, diodes and sixteen serpentine resistors were connected from faint colour differences where metal had once protected the silicon. The result is four DTL NAND gates. In each one, input diodes steer the current from a resistor either away from the first transistor or into it; only when both inputs are high do both transistors switch on and pull the output low. An extra diode in the middle raises the switching threshold and makes the gate less sensitive to noise, and a resistor rather than a transistor pulls the output high, which wastes power whenever the output is low.
Two details stand out. The power pins are on a diagonal, as on later TTL parts, but on the other diagonal: ground on pin 1 and supply on pin 8, instead of 7 and 14. And the die carries two diodes that the quad NAND never uses. Shirriff's explanation is that Signetics built several products from one silicon layout and changed only the metal mask. The same die, wired differently, becomes the 670A with three three-input gates, using a diffused crossunder to route signals beneath the supply lines, and the 616A with two five-input gates, which is where the spare diodes are needed. A metal mask is far cheaper than a full mask set, an approach Signetics also sold as semi-custom circuits under the name variFEBS.
The post closes with company history: Signetics announced its first product, a NAND gate, in 1962 at $125, Corning Glass bought 51 percent of the company, and Fairchild's faster and cheaper 930 series later took much of the DTL market.

Why it matters
Two diodes that do nothing in the quad gate turn out to be evidence of a cost decision: one die, three catalogue parts, and the metal mask as the only difference. Reading a chip this way also shows why the unused parts of a design are often the most informative.